Project at a Glance:Here is a quick overview of my EV project.
- Get Enova controller working.
- Choose vehicle.
- Adapt motor for transmission.
Project Objectives My project objectives are as follows. - Obtain software for Enova Controller
- Obtain schematics for Enova Converter.
- If I can't get schematics from Enova. Reverse engineer Enova controller so that I can design car wiring harness.
- Decide what brand of lithium battery I should use.
- Obtain Battery Management System.
- Install Batteries and BMS.
- Install 3-phase motor.
- Install controller.
- Connect controller and batteries.
|
Recent List Items
| Title | Assigned To | Status | Priority | Due Date | % Complete |
Rolling Updates
-
Linear LTC6802-1 BMS 12 cell management.
This is a 12 cell Battery Management chip with MOSFET driver circuit.Here is a link to the chip made by Linear Technologies - http://www.linear.com/product/LTC6802-1 ...
Posted Feb 24, 2012 8:46 PM by Paul Schilling
-
Donor Car.
I would like an opinion on what type of vehicle I should use for the chassis of the Electric Vehicle.
Posted Dec 6, 2011 8:44 PM by Paul Schilling
-
Enova Configuration Software
Enova configuration software PDS32 running under Wine in MacOS X on an intel i7 processor.
Posted Dec 1, 2011 8:18 PM by Paul Schilling
-
Similar Project from member of MNEAA.
This was posted to youtube by Dale a member of the MNEAA Minnesota Electric Auto Association. It uses the same 3 phase motor as I am using. The controller will ...
Posted Dec 7, 2011 8:17 PM by Paul Schilling
-
Metri-Pack Sealed GPIO connector
I found the connector for connecting the accelerator POT, lights, diagnostics, and gauge outputs for the inverter. This connector is a Metri-Pack 150 series connector made by Delphi. The ...
Posted Nov 21, 2011 8:43 PM by Paul Schilling
|
|